Intruder Alarm Control Panel & Keyfob

Product ID: MCP-6RC / RCP-6

Send Inquiry
The MCP-6RC is an independent, remote controllable 6-zone alarm control panel designed for today's residential or commercial security system.

Utlizing a powerful microprocessor, MCP-6RC control panel offers 6 fully programmable alarm zones plus separate Tamper and PA zones to provide maximum security to all levels of property owner.

Smart Automatic Diagnosis of Loop Resistance (ADLR) makes this panel available with NC or NO alarm sensors. Further numerous features and operation modes can be set and programmed via its on-board keypad or optional remote control keypad RKP-6.

The MCP-6RC can be remotely armed / disarmed by RCP-6 remote control keyfob.

Specifications
  • Mains power: 110 / 230 VAC, 50/60Hz
  • Current drain: 2.5W max. @disarmed status
  • Protection zones: Total 8, incl. 6 Alarm, 1 Tamper, 1 PA
  • Alarm relay: C-type, 10A, 250 VAC resistive load.
  • Bell output: 13.8 VDC, 200 mA
  • DC power output: 13.8 VDC, 500 mA max.
  • Alarm zones: NC or NO programmable
  • Tamper: NC, 24 hours standby
  • P.A.: NC, 24 hours standby
  • Output fuse: 1.5 Amp. 5 x 20 mm
  • Alarm event log: Max. 32 events
  • Standby battery: 12V, 1.2 ~ 3.2 AH rechargeable
  • EOL resistor: 1.2K ~ 7.2K, 4.7Kohm recommended
  • Operation codes: 10, incl. 1 master, 8 user, 1 cleaner
  • Exit/entry delay: 0 ~ 999 seconds programmable
  • Bell output time: 0 ~ 99 minutes programmable
  • Door chime time: 0 ~ 9 seconds programmable
  • Strobe output: Latched after alarm until formal reset
  • Remote control: Max. 10 RCP-6 remote control keyfob
  • Temperature: -20°C ~ 50°C (-4°F ~ 122°F)
  • Dimensions: 260 x 210 x 80 mm
Features
  • 6 fully programmable alarm zones+Tamper+PA.
  • Auto reset and rearmed after alarm condition.
  • Automatic Diagnosis of Loop Resistance.
  • Back-up battery low voltage warning indication.
  • Multiple alarm outputs (relay, strobe and bell).
  • Maximum 32 alarm events memory log.
  • Safe-N-Quick arming code operation.
  • System setup EEPROM Non-volatile memory.
  • 10 user codes (1 master, 8 user, 1 cleaner).
  • Programmable End-of-Line resistor value.
  • Programmable alarm trigger count.
  • Programmable alarm output durations.
  • Programmable door chime function.
  • RCP-6 remote control keyfob included.

Main Products

Wireless Security System, HomeKeeper PIR Motion, Occupancy Sensor, PIR Motion Sensor Module

Contact Detail