LINEEYE Co., Ltd.

CAN/LIN Communications Expansion Kit for LE-2500-E/LE-3500-E

Click here for details.

Includes expansion board and firmware for CAN and LIN communications mainly used for in-vehicle network.

• Outline
• OP-SB7GX is the expansion kit which makes it possible to monitor, and simulate CAN and LIN communications. It enables monitoring of CAN and LIN data in any combination up to 2 channels at a time. Suitable for evaluation of mixed in-vehicle networks of CAN and LIN.
• Operating Instructions
• After inserting the expansion board into the analyzer, connect to the CAN BUS using the included monitor cable. For ISO11898, the terminator can be set by use of the jumper pin of the expansion board. You can select CAN (ISO11898 or ISO11519-2) or LIN from your analyzer. For CAN, connect to the CAN BUS using the included CAN monitor cable. For LIN, connect to the LIN BUS using the included LIN monitor cable.
• Monitoring
• Since measurement data is recorded with time stamp in 1ms unit at the same time, error timing can be easily detected. Also, efficient analysis is possible by using the ID filter. Supports the standard format (11bit ID) and the expansion format (29bit ID) for CAN. You can customize bit timing for every channel, and measure based on the actual CAN BUS state. You can set speed settings arbitrary and calculation method of the Checksum for every channel in the case of LIN.
• Trigger
• The trigger function enables you to use some condition and measurement operation of after the condition is specified, such as receiving specific data frame and remote frame etc., up to four pairs as the trigger. It can be used as a sequential trigger which enables another trigger conditions as satisfied action of some trigger conditions. Therefore, It is useful for intermittent analysis of troubles.
• Simulation
• [CAN]The simulation function makes it possible to transmit the data frame and remote frame of the standard and expansion format with one click. Also, it can transmit changing data at the appointed time in order. Those functions are very useful for development of CAN BUS and DeviceNet equipment.
• [LIN]Supports both Master and Slave. At the time of Master, it is possible to perform the data transmission and the one-touch transmission following the schedule.At the time of Slave, transmits when meeting with ID set to the data table. Also, it is possible to transmit Wake-up (80h) and Error frame (BREAK, SYNC, Parity, Checksum etc.).

Main Products:
Multi Protocol Analyzer, USB Protocol Analyzer, LAN Analyzer

• Email this page
• Bookmark this page
• Print this page