Specifications:
- Grade - K05/D05
- Application - hard cast iron, plastic, porcelain, fiber, cutting with small chip sections
- Grade - K10/D1
- Application - grey cast iron over HB 220, cutting with medium or small chip sections
- Grade - K20/D2
- Application - grey cast iron below HB 220, wood, non-ferrous metals, turning with medium or large chip sections
- Grade - K30/A4
- Application - low hardness cast iron, wood, non-ferrous metals, turning with large chip sections
- Grade - K40/D3
- Application - powder compacting dies, wire (pipe) drawing dies, heavy interrupted cutting and high feed rate turning
- Grade - K50/D4
- Application - deep drawing dies, punching dies, mining tools, extra heavy duty turning tools
- Grade - G30/D5
- Application - cut-off dices, trimming dies
- Grade - G35/D55
- Application - trimming dies, punching dies
- Grade - G40/D6
- Application - punching dies, heading dies
- Grade - G45/DH
- Application - heading dies, extrusion dies, heavy punching dies
- Grade - G50/D7
- Application - nut forming die nibs, extra heavy punching dies
- Grade G60/DX
- Application - special nut forming die nibs, super extra heavy punching dies
- Grade P10/M10
- Application - steel, turning with medium or small chip sections
- Grade P20/M20
- Application - steel, turning with medium or large chip sections
- Grade P40
- steel, turning with large chip sections
- Minimum Order: Negotiable
- TEL: 886-2-2268-6995
- FAX: 886-2-2268-6885
- E-mail: peaktech@ms3.hinet.net