Shrink Fit Tooling
Shrink Fit Tooling
1.The shrink tool in figure1 employs induction coils to heat the tool shank.
2.In figure 2, the shrink fit tool pertaining the concept of changing the volume of an item by heating/cooling. The processed item can be used after cooling.
With shrink fit toolholders vibration is reduced and cutting is noticeably faster and smoother.
A shrink fit tool holder includes a shank or body
Shrink fit tooling is an increasingly popular toolholding system for high speed machining and other applications where minimal runout and good balance are required.
With shrink fit tooling, expansion and contraction of the toolholder bore is uniform. The underlying principle behind the shrink fit tooling system is to use a minimum amount of heat to expand the toolholder body.
Find out more of our hot products :
Cap Sealing
Heat Treatment Equipment
Induction Heating
Sealing Machine
Shrink Fit Tooling
- Input Power: 1Ø 220V, 50 / 60 Hz
- Output Power: Max 6,000W
- Current: 20 ~ 25A
- Frequency: 30 ~ 50 KHZ
- Size (L x W x H)
- 305 x 365 x 686mm
- 435 x 335 x 705mm
- N.W / G.W: 28 / 48 Kg
- Clamping Range: Ø6mm ~ Ø32mm
- Operation: Manual
- Coil: 1
- Suitable shrink fit various tool chuck with high clamping force.
- Fast tool, loading and unloading.
- Operational interface is easy to understand operate.
- Low heating power for saving energy consumption.
- Precise heating control extends the service life of tool shrink fit.
- Adjustable for tool length.
- No magnetization on tool after heating.
- High investment efficiency. Fast pay back.
- Technical Information
- Suitable for various tool shrink fit tapers.
- Tool diameter range 6 ~ 32mm.
- Tool shrink fit length is of up to 300mm.
- Applicable for H.S.S. and T.C.T. tools.
- Tool shrink fit and tool diameter tolerances are under 3μm.
- Heating tome required is about 10 ~ 20 seconds, which may vary with tool diameter (Tool change time is about 5 minutes).
- Single phase 220V power source.
- Output power 6,000W.
- Dimensions two different:
- 305(L) x 365(W) x 686(H) mm, net weight 28kg.
- 435(L) x 335(W) x 705(H) mm, net weight 28kg.
- Working Principle of Shrink Fit
- Apply induction coils for heating the tool shrink fit.
- Shrink fit the tool into the shank by using the principle of hot expanding and cold shrinking. After cooled, the tool can be used.
-
Main Products:
Aluminum Foil Induction Cap Sealing Machine, Portable High Frequency Induction Heating Generator, Induction Heating Equipment, Induction Melting & Forging Furnace, Induction Shrink Fit Tooling, Heat Treatment Equipment, hardening equipment for linear rail / guideway, ball screw.
