Product ID: W-1170S

Sliding Headstock Type-Automatic Lathe

This machine is a single spindle automatic lathe with sliding headstock, which is designed for turning precision small parts, as Watch, Camera, Optical equipment, Radio & TV set, Communication equipment, Sewing machine and Hardware parts etc.

Click here for details.

Features:

• Headstock: The headstock is controlled by the plate cam which provides the longitudinal motions. The transmission ratio for the headstock can be changed from 3:1 to 1:1. It is made of special steel through high frequence heat treatment and precision grinding. It supported with four precision antifriction bearings. The front two bearings are needle roller bearings to reduce the friction and at the rear are adjustable angular contact bearings. Bearings support the pressure of the spindle and the tension of the belt. Any play can be self-adjusted.
• Tool Stand: Five turning tools are arranged radially around a guide bushing, the combinations with the radial movements of the turning tools and the longitudinal movements of the headstock which is suitable for turning precision long parts. This is the features of the sliding headstock automatic lathe. Tool No.1 and No.5 are controlled by the plate cams. Tool No.2, 3 and 4 are controlled by the individual bell cams. All the five tool slides can be adjusted both in radial and axial directions. Tool No.1 and No.5 only could be used for radial adjustment by the micrometer screws (0.005m/m per division). The transmission ratio from the cam to the cutting edge of Tool No.1 and No.5 are 3:1, and the other tools are 2:1 to 3:1.
• Three-Spindle Drilling & Threading Attachment: These attachments are available for centering, drilling, counter-sinking, right-hand and left-hand threads. They are drived by a double cone clutch device and two separately tensioned flat belts. For thread cutting, the speed of the headstock spindle remains the same, while the speed of the threading tool is increased or reduced. The attachment spindles can be used as follows:
• Spindle (No.1): Rotation - Stop or Reverse / Action - Centering, Drilling
• Spindle (No.2): Rotation - Normal or Reverse / Action - Threading, Drilling
• Spindle (No.3): Normal or Stop / Action - Threading, Drilling
• Threading Controlled Device: The attachment spindle speed must be varied while cutting thread. The attachment spindle runs at a speed faster or slower than the main spindle depending on the two belts of the cone clutch. It can be used for cutting long thread, right-hand and left-hand threads.
• Gear Box For Changing Speeds: The speed of the headstock spindle can be selected from 7 different speeds by changing the position of V-Belt on the 7-grooved Pulley. The camshaft speed can be selected from 24 different speeds for each different speed of the spindle by changing the gear ratio of gear box.
• Bar Feed Device: This device is to feed the material into the headstock spindle by means of push-rod and balance weights. The material can be available up to 3 meters long. When the material has been used up, the camshaft clutch is disengaged automatically, the camshaft stops in a position given in advance and the red lamp lights up.

• Minimum Order: Negotiable
• TEL: 886-6-2616118 ~ 0
• FAX: 886-6-2911505
• E-mail: wangtzyy@ms46.hinet.net