Logic Pulser
Product ID: LP-540H
The K & H LP-540H logic pulser is a very effective tool for inspecting and repairing the logic circuits. It can be used directly to inject a signal into the logic circuits without removing the IC or reading the circuits. Using the logic probe as a monitor, you can not only know the wiring errors but also check out components malfunctional. The reason is that it can produce a very large transient current in a moment.
- Sync input impedance: 1M Ohms
- Pulse repetition rate: 0.5pps / 400pps
- Pulse width in pulse output at 100mA load: 100Mus
- Output current:
- Pulser mode: 100mA sink/source
- Square wave output: 5mA sink/source
- Powr supply protection: +/-25V / 25sec
- Output protection: +/-35V / 15sec
- Size: 212 x 26.5 x 18mm
- Weight: 65g
- Maximum allowable supply voltage: +/-20V
- Operating supply voltage range: 3~15V max.
- Output allowable connection voltage: +/-35V
- Free air operating temperature range 0~50 Celsius max. sync input voltage: +/-120V / 15sec
- The logic pulser also can use with changeable external terminal
- Red terminal: to extend probe leads
- Black terminal: to extend ground point to circuit
Main Products:
breadboarding & accessories, electronic educational systems, educational training equipment
