Product ID: GCU-2000

Digital Gen - Set PLC Control Unit

Provides Full Instrumentation & Protection On Any Generator Set.

Click here

Click here for details.

• Power Input: Voltage 9 ~ 36 VDC (12V, 24V)
• Sensing Input
• Voltage: 15 ~ 500 VAC 3Phase 4Wire.
• Frequency: 50 / 60Hz
• MPU Signal Input
• Voltage: ±2 ~ ±70 VAC
• Frequency
• Min.: 100Hz
• Max.: 10KHz
• CT Specification: Burden 2.5 VA
• Power Dissipating: Max. 7 Watt
• Operating Temp.: -20 ~ 70°C
• Relative Humidity: < 95%
• Max. Vibration:
• 5 ~ 25Hz ±1.6mm
• 25 ~ 100Hz a=4g
• Large LCD Display
• Programmable Display with 3 Phase Volts, Amp & Freq.
• Engine Operation Hours & Battery Voltage Display
• Can Display Different Unit Of Temperature & Oil Pressure
• Failure Signal Status By Graphic Display
• Protection & Alarm Status
• Engine Start Failure
• Engine Over Speed
• Sensor Failure
• Abnormal AC Voltage
• Low Engine Oil Pressure
• Emergency Stop Activated
• High Engine Temp.
• MPU Failure
• Generator Over Load
• Abnormal Battery Voltag
• Customized settings are auto-saved into memory and will remain even when power is off
• Provide gen-set run-in modulate model and manual start and stop functions, when user proceed modulate controller will shut down all protect functions.

Features:

• Micro-Processor auto control & protection.
• Easy to read large LCD display.
• Modularity design, easy to install.
• Provide accurate temperature and oil pressure display.
• Provide full engine & generator alarms signals shutdowns.
• All Functions Setting: Can be done directly on GCU2000 No need for PC connection.
• Provide emergency stop and voltage adjustment on front panel.
• RS-232 communication interface.
• Total Of 15 Memorable Event Logs

• Minimum Order: Negotiable
• FOB: TAIWAN
• TEL: 886-7-8121771
• FAX: 886-7-8121775
• E-mail: kutai2008@kutai.com.tw