Provides Full Instrumentation & Protection On Any Generator Set.
Specifications:
- Power Input: Voltage 9 ~ 36 VDC (12V, 24V)
- Sensing Input
- Voltage: 15 ~ 500 VAC 3Phase 4Wire.
- Frequency: 50 / 60Hz
- MPU Signal Input
- Voltage: ±2 ~ ±70 VAC
- Frequency
- Min.: 100Hz
- Max.: 10KHz
- CT Specification: Burden 2.5 VA
- Power Dissipating: Max. 7 Watt
- Operating Temp.: -20 ~ 70°C
- Relative Humidity: < 95%
- Max. Vibration:
- 5 ~ 25Hz ±1.6mm
- 25 ~ 100Hz a=4g
- Large LCD Display
- Programmable Display with 3 Phase Volts, Amp & Freq.
- Engine Operation Hours & Battery Voltage Display
- Can Display Different Unit Of Temperature & Oil Pressure
- Failure Signal Status By Graphic Display
- Protection & Alarm Status
- Engine Start Failure
- Engine Over Speed
- Sensor Failure
- Abnormal AC Voltage
- Low Engine Oil Pressure
- Emergency Stop Activated
- High Engine Temp.
- MPU Failure
- Generator Over Load
- Abnormal Battery Voltag
- Customized settings are auto-saved into memory and will remain even when power is off
- Provide gen-set run-in modulate model and manual start and stop functions, when user proceed modulate controller will shut down all protect functions.
- Micro-Processor auto control & protection.
- Easy to read large LCD display.
- Modularity design, easy to install.
- Provide accurate temperature and oil pressure display.
- Provide full engine & generator alarms signals shutdowns.
- All Functions Setting: Can be done directly on GCU2000 No need for PC connection.
- Provide emergency stop and voltage adjustment on front panel.
- RS-232 communication interface.
- Total Of 15 Memorable Event Logs
- Minimum Order: Negotiable
- FOB: TAIWAN
- TEL: 886-7-8121771
- FAX: 886-7-8121775
- E-mail: