Kutai Electronics Co., Ltd.

Home > Products > Electrical and Electronics >Heavy Electric Machinery >Generator >AC Generator

Generator Automatic Control and Protection Module

Product ID: GCU-100

GCU-100

Click here for details.

Generator Automatic Control and Protection Module

Click here

Specifications:

Panel Display

Fixed or Circulating Full Phase Voltage, Current and Frequency* Starter Cranking time: 1 ~ 15 Seconds
Engine Operation Hours
DC Voltage(Battery)
Delay Countdown Display

Protection & Alarm Status

Engine Start Failure
Emergency Stop Activated
High Engine Temperature
Low Engine Oil Pressure
Engine Over & Under Speed
Abnormal AC Volt
Generator Over Load
Low Fuel Level
Charge Motor Failure
Abnormal DC Volt
Scheduled Maintenance Warning
Free Programmable warning

Environment

Operating Temperature -20~70 °C
Relative Humidity < 95%
Max. Vibration 5~25 Hz , ± 1.6 mm , 25~100 Hz , a=4g

Specifications

Power Input: 9~35 VDC (12V , 24V)
Sensing Input: Voltage 15~510 VAC
Frequency 50/60 Hz
MPU Signal Input: Voltage ±2 to ±70 VAC
Frequency Min.100 Hz , Max.10 KHz
CT Specification: Burden Above 2.5 VA
CT Secondary Ratio: 5A
Power Dissipation: Max. 5 Watt
Panel Installation Cut-Out: 137.0 ± 0.5 mm x 137.0 ± 0.5 mm
Weight: 610 g ± 2%

Features:

Micro-Processor Auto Control Protection
Three Sets of High Illuminating LED Display Suitable for Indoor and Outdoor Use
Full Function Modularized Design for Easy Installation
All Functions Setting Can Be Done Directly On GCU-100 No Need For PC
Connection (User can Program, Change and Cancel Protection and Warning Settings according to the requirement)
All settings are recorded into the internal (EEPROM) and protected from erasure even without battery
Easy to Understand Graphical Warning Signals
Din Rail Terminal For Easy Installation
IP65 Waterproof Front Panel

Main Products:
Engine control unit, Transfer Switch, Generator Voltage Regulator, Automatic Transfer Switch, Automatic Voltage Regulator, Automatic Battery Charger, Electronic Governor Controller, ATS Controller and Genset Controller