Reusable - Humidification Chamber
Product ID: HC-02
The HC-02 is a reusable humidification chamber for use with any compatible humidifier heater bases and is recommended for adult applications. The chamber is used to provide humidification for intubated or non-intubated patients.
- Set up and Operation:
- Ensure that the chamber and circuit are connected well before use.
- Refer to the humidifier operating manual for recommended set-up on the humidifier.
- Replace and Sterile the chamber in accordance with hospital infection control procedures.
- Warning:
- "X"demotes water level too high,"V"demotes max. water level
- DO NOT fill the chamber above the max. fill level line. Liquid could enter the breathing circuit if the chamber is overfilled.
- DO NOT fill the chamber with water in excess of 36°C.
- If a waterfeed set is used, ensure the water bag is placed below the level of the humidifier after the chamber has been filled.
- Ensure the humidifier as not tilted. Tilting the humidifier may result in water entering the breathing circuit.
- Do not touch the heater plate or chamber base.
- Do not exceed a maximum peak flow rate of 180L/min.
- Cleaning: (Chambers maybe cleaned by any of the following methods)
- AUTOCLAVE:136°(277°) @220Kpa(32Psi) for 4minutes or 120°C(248°F) @96Kpa(14.1Psi) for 15 minutes.
- E.T.O: 55°C(131°F)
- Pasteurisation:
- Chemical Immersion: Solutions such as Medizyme Pyroneg, Control 3, Solution 2 Cidex have been tested according to the manufacturers directions. Other brand names with similar active ingredients may also be suitable.
- Warming:
- The following solutions should be avoided as they may cause the chamber to crack:
- Ketone/Formaldehyde/ChlorinatedHydrocarbons/Hypochlorite/Inorganic Acid/
- Aromatic Hydrocarbons/Phenol(>5%)
| Gas Ports | Inlet 22mm M/ outlet 22mm M | Max Peak Flow | 180L/min |
|---|---|---|---|
| Compressible Volume | Empty: 330ml | Air Resistance | 0.2cmH2O @30LPM |
| - | Full: 200ml | Modulus of Elasticity | 0.6㏄/ cmH2O |
| Max. Water Capacity | 200ml | Absolute Temperature | >34mg/L (10-100LPM) |
| Base dia. | 10.5 cm | Dome | 110mm |
| Material | Dome / K-resin | Base / Stainless steel | Gasket / Synthetic Rubber |
Main Products:
Breathing circuit bacterial filter,Anesthesia breathing circuit, suction catheter, Heat & Moisture Condenser(HME), Copolymer Glove
Contact Details
CEO: Mr. Billy Liang
Sales Contact: Manager Billy Liang
Minimum Order:Negotiable
Address:No. 65-2, Erh Chia Road, Ying Kuo Chen, Taipei Hsien Taiwan, R.O.C.
Tel:886-2-26780366
Fax:886-2-26708811
E-mail:
say.kia@msa.hinet.net